[Linux-bruxelles] lenteur défilement console SUSE
Didrik Pinte
pinted at tiscali.be
Lun 16 Fév 20:23:40 CET 2004
On Mon, 2004-02-16 at 19:39, eric hanuise wrote:
> installe et configure hdparm, ca peut venir de la, tout betement.
hdparm est installé et semble bien configuré. J'ai ajouté l'output de
"hdparm -I /dev/hdc". Ca semble correct, non ?
Didrik
----------------------------------------------------------------------
/dev/hdc:
multcount = 16 (on)
IO_support = 0 (default 16-bit)
unmaskirq = 0 (off)
using_dma = 1 (on)
keepsettings = 0 (off)
readonly = 0 (off)
readahead = 8 (on)
geometry = 7296/255/63, sectors = 117210240, start = 0
ATA device, with non-removable media
Model Number: FUJITSU MHT2060AT
Serial Number: NN18T3814E4U
Firmware Revision: 009B
Standards:
Used: ATA/ATAPI-6 T13 1410D revision 3a
Supported: 6 5 4 3
Configuration:
Logical max current
cylinders 16383 16383
heads 16 16
sectors/track 63 63
--
CHS current addressable sectors: 16514064
LBA user addressable sectors: 117210240
device size with M = 1024*1024: 57231 MBytes
device size with M = 1000*1000: 60011 MBytes (60 GB)
Capabilities:
LBA, IORDY(cannot be disabled)
bytes avail on r/w long: 4 Queue depth: 1
Standby timer values: spec'd by Standard, no device specific minimum
R/W multiple sector transfer: Max = 16 Current = 16
Advanced power management level: 128 (0x80)
Recommended acoustic management value: 254, current value: 254
DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* READ BUFFER cmd
* WRITE BUFFER cmd
* Host Protected Area feature set
* Look-ahead
* Write cache
* Power Management feature set
Security Mode feature set
* SMART feature set
* Mandatory FLUSH CACHE command
* Device Configuration Overlay feature set
* Automatic Acoustic Management feature set
SET MAX security extension
Power-Up In Standby feature set
* Advanced Power Management feature set
* DOWNLOAD MICROCODE cmd
* SMART self-test
* SMART error logging
Security:
Master password revision code = 65534
supported
not enabled
not locked
frozen
not expired: security count
not supported: enhanced erase
60min for SECURITY ERASE UNIT.
HW reset results:
CBLID- above Vih
Device num = 0 determined by the jumper
Checksum: correct
----------------------------------------------------------------------
Plus d'informations sur la liste de diffusion Linux-bruxelles